1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
|
// This is a minimal 16550 UART driver for COM1, this is
// mainly going to be used for debugging since its really
// simple to setup. Fun fact: i was drunk when i wrote this
//
// see: https://wiki.osdev.org/Serial_Ports
const COM1: u16 = 0x3F8;
inline fn outb(port: u16, val: u8) void {
asm volatile ("outb %[val], %[port]"
:
: [val] "{al}" (val),
[port] "N{dx}" (port),
);
}
inline fn inb(port: u16) u8 {
return asm volatile ("inb %[port], %[result]"
: [result] "={al}" (-> u8),
: [port] "N{dx}" (port),
);
}
// 38400 buard
// 8 data bits
// no parity
// one stop bit
// FIFO on
// Idempotent so it should be relatively safe to call
// from the panic handler.
pub fn init() void {
outb(COM1 + 1, 0x00); // no interrupts
outb(COM1 + 3, 0x80); // DLAB on: the next two writes set the baud divisor
outb(COM1 + 0, 0x03); // divisor 3 -> 38400 baud (low byte)
outb(COM1 + 1, 0x00); // divisor high byte
outb(COM1 + 3, 0x03); // DLAB off, 8N1
outb(COM1 + 2, 0xC7); // enable + clear FIFOs, 14-byte trigger
outb(COM1 + 4, 0x0B); // RTS/DSR set
}
// COM1+5 (bit 5) = transmit holding register and
// spin until it's clear to send
fn putc(c: u8) void {
while (inb(COM1 + 5) & 0x20 == 0) {}
outb(COM1, c);
}
pub fn write(s: []const u8) void {
for (s) |c| putc(c);
}
|
